BS 5411 Pt.7-1980 金属和有关覆层的试验方法.第7部分:测量覆层厚度的轮廓曲线仪法

上一篇: BS 5411-6-1980 金属和有关覆层的试验方法.第6部分:维氏和努氏显微硬度试验
下一篇: BS 5411 Pt.10-1980 金属和有关覆层的试验方法.第10部分:金属基体上电积和化学沉积金属镀层附着力试验方法的评述

【英文标准名称】:FixedRadioSystems-Conformancetesting-Part3-1:Point-to-Pointantennas-Definitions,generalrequirementsandtestprocedures(EndorsementoftheEnglishversionEN301126-3-1V1.1.2(2002-12)asGermanstandard)
【原文标准名称】:固定无线电系统.合格检验.第3-1部分:点对点天线.定义、一般要求和试验程序
【标准号】:DINEN301126-3-1-2004
【标准状态】:现行
【国别】:德国
【发布日期】:2004-06
【实施或试行日期】:
【发布单位】:德国标准化学会(DIN)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:定义;电信;电气工程;远程通信;合格试验;复接;术语;天线;信息处理;中继无线电;传播技术
【英文主题词】:Antennas;Communicationtechnology;Conformitytesting;Definition;Definitions;Electricalengineering;Informationprocessing;Multiplexing;Relayradio;Telecommunication;Telecommunications;Terminology
【摘要】:ThisEuropeanstandardspecifiesrequirementsinthetelecommunicationssector.
【中国标准分类号】:M36
【国际标准分类号】:01_040_33;33_120_40
【页数】:2P;A4
【正文语种】:德语


Product Code:SAE J1884
Title:Vehicle Jack Requirements and Test Procedures
Issuing Committee:Vehicle Jack Committee
Scope: The scope of this SAE Recommended Practice is restricted to the testing of jacks supplied as original equipment on passenger cars, light trucks, and vans. To this end, both component suppliers and vehicle manufacturers are guided in the proper design and testing of jacks. The purpose of this document is to provide a test procedure that can be used to ensure reasonable quality and uniformity for vehicle jacks as supplied as original equipment.